The correct way to fit the bar row of the oil press is as follows:
Ensure that the oil press is off and disconnected from the power supply.
Remove the hood or cover of the press to access the bar row area.
Remove the barrow plate from the press and clean the barrow plate and the inside of the press of any residue.
Check the markings or instructions on the striker plate to ensure proper installation. Typically, the barrow plate will have an arrow or marking on it indicating the correct direction for installation.
Place the barrow plate back into its designated position in the press to ensure proper alignment with the other components. Take care to ensure that the barrow plate corresponds with the oil guide grooves inside the press to ensure proper oil flow.
Carefully observe the installation of the barrow plate to ensure that it is mounted flat and tightly inside the oil press with no looseness or tilting.
Reinstall the hood or cover of the oil press and make sure that all fixing screws or buckles are properly installed.
Connect the power supply and turn on the power switch of the oil press.
Specific installation procedures may vary depending on the oil press model and manufacturer’s requirements.
gao
Henan Zhongrui Grain is a high-tech enterprise specializing in the research, development, manufacture and sales of oil press equipment, and has been deeply engaged in the field of oil processing for more than ten years. The company integrates design, production and testing, and its products cover screw oil press, hydraulic oil press, automatic refining production line, etc., which are suitable for rapeseed, peanut, soybean, sesame and other oilseeds, and help customers to realize efficient, energy-saving and environmentally friendly oil and grease production.
